ABSTRACT This study demonstrates the usage of primarily discarded waste – pomegranate peel as secondary raw material – biosorbent for broader applications. The focus was on the optimisation of key cationic dye methylene blue (MB) – pomegranate peel (PP) adsorption process parameters, as well as cost analysis assessing the possibility of scaling up. The optimal values of the key parameters were pH 6, biosorbent mass 100 mg, contact time of 50 min, and initial analyte concentration 100 mg/L for MB removal from aqueous solutions providing high removal efficiency values > 88%. Fourier-transform infrared spectroscopy (FTIR) showed that MB adsorption on PP was presumably via hydrogen bonds with the OH groups present in PP. Changes noted via elemental composition analysis given by electron dispersive spectroscopy (EDS) confirmed the sorption of MB. Biosorption occurred mainly as a pseudo-second-order kinetic reaction combined with phase III of the intraparticle diffusion model (both R2 ≥ 0.92). Through a simple and fast batch MB sorption process with many advantages compared to literature data, a maximum sorption capacity of 384.61 mg/g could be achieved. Pomegranate peel was identified as a low-cost adsorbent with excellent potential for MB removal, economically viable (0.74 $/mol), demonstrating great possibilities for industrial application. Highlights Biosorption of phenothiazine dye on novel waste material from pomegranate peel in its native form. A univariate general procedure was performed, FTIR, SEM, and EDS characterisation of biosorbents. An optimal pH value was determined to be 6, while the optimal mass was 100 mg. A maximum biosorption capacity of 384.61 mg/g could be achieved. The mechanism of adsorption is best obeyed by the Langmuir and Freundlich models. The total analysis expenses for the entire procedure were just 0.74 $/mol. GRAPHICAL ABSTRACT

Abstract Simultaneous adsorption of heavy metals in complex multi metal system is insufficiently explored. This research gives results of key process parameters optimization for simultaneous removal of Cd(II), Co(II), Cr(III), Cu(II), Mn(II), Ni(II) and Pb(II) from aqueous solution (batch system). New lemon peel-based biomaterial was prepared and characterized by infrared spectroscopy with Fourier transformation (FTIR), scanning electron microscopy (SEM), electron dispersive spectroscopy (EDS), while the quantification of metals was made by atomic absorption spectrometry (AAS). Simultaneous removal of seven metals ions was favorable at pH 5 with 300 mg/50 mL solid-liquid phase ratio, within 60 min at room temperature with total obtained adsorption capacity of 46.77 mg g−1. Kinetic modeling showed that pseudo-second order kinetic and Weber-Morris diffusion models best describe the adsorption mechanism of all seven heavy metals onto lemon peel.

This article reports on an investigation into the ability of SiO2–Ta2O5 as a new sorbent for simultaneous preconcentration of Cd(ii), Co(ii), Cr(iii), Cu(ii), Fe(iii), Mn(ii), Ni(ii) and Pb(ii) ions from water by the column method and the parameters involved in this process.

This study evaluates the genotoxic potential of two Ru(III) complexes with thiosemicarbazone based ligands. The complexes were tested for in vitro protective effect on chromosome aberrations in peripheral human lymphocytes using the cytokinesis block micronucleus (CBMN) assay at concentrations 1.5; 3.7 and 7.4 μg/mL. The cell culture treated with the tested complexes, at 3.7 μg/mL concentration, decreased a frequency of micronucleus for 37% and 32%, when compared with the control cell cultures. At concentration of 7.4 (1.5) μg/mL of this complexes exhibited slightly lower effect of micronucleus for 30% (35%) and 27% (29%), when compared with the control cell cultures.