Abstract This paper presents a detailed model of low-frequency oscillations and their damping within the Electric Power System (EPS) of Bosnia and Herzegovina (B&H). The system is modeled using MATLAB software, analysing the steady state and dynamic responses. This research highlights the challenges and impacts of integrating renewable energy sources, such as wind farms, on grid stability and oscillation damping. The paper utilizes eigenvalue analysis to investigate the dynamic characteristics of the system, emphasizing the need for efficient damping strategies to maintain system stability. The methodology includes a comprehensive review of existing literature, the creation of a detailed EPS model of B&H, and the application of eigenvalue and oscillation amplitude analysis to determine damping ratios. The dynamic responses of hydro power plants, HPP Mostar and HPP Jablanica, to transient disturbances are analysed to validate the model and refine damping strategies. The results indicate that the B&H EPS is well-damped, with all eigenvalues possessing negative real parts, and demonstrate the system’s resilience to small disturbances. The results are compared with the technical report on the integration of the wind power plant WPP Podveležje. This comparative analysis shows consistent patterns between the modeled calculations and empirical data, confirming the robustness of the EPS model. This alignment underscores the effectiveness of current damping mechanisms and provides a foundational strategy for enhancing system stability with increasing renewable energy penetration. The findings highlight the importance of developing advanced control strategies to sustain system stability as the integration of variable renewable energy sources continues to grow.

Abstract The methodology for the evaluation of long-term exposure to the overhead line magnetic field is presented, in this paper. The developed methodology is based on the ambient temperature measurements and phase conductors’ height measurements to find a linear regression model to determine phase conductors’ height changes for different ambient temperatures. Based on the overhead transmission line geometry, and datasets about historical overhead line phase current intensity values and ambient temperatures long-term magnetic field exposure can be determined. For magnetic flux density determination, a method based on artificial neural networks is used. The methodology is applied to the case study of overhead line that connect substations Sarajevo 10 and Sarajevo 20. A period of one year is analyzed and magnetic flux density values are determined. The obtained results indicate that during the analyzed period for significant amounts of time magnetic flux density values surpass the recommended values for long-term exposure.

Due to the significant growth in the number of devices, the range of services it provides, and strict air conditioning requirements, the telecommunications infrastructure is becoming an increasingly important electricity consumer. The efficiency of the power supply system and the power quality are significant challenges in the design and maintenance of telecommunications infrastructure elements. In such systems, power electronic converters play an indispensable role. This paper discusses the results of power quality measurements for supply systems of telecommunications devices. The power supply systems of telecommunications devices with different power converters were analyzed. Also, the power supply of a mobile telephony base station at a remote location was considered, with special reference to the reaction of battery storage in the event of a power outage. Obtained results demonstrate that it is necessary to treat such consumers with special care and take measures to limit their emission of current harmonics.

This paper presents the use of the Hilbert-Huang Transform (HHT) to identify low-frequency electromechanical oscillatory modes, their characteristics, and damping. As these oscillations can have varying features, locations, and impacts on power systems, identifying and monitoring them is crucial for the monitoring, protection, and control of modern power systems. The Hilbert-Huang transform (HHT) is a technique used to analyze nonlinear and non-stationary time series data. It involves breaking down the data into components using Empirical Mode Decomposition (EMD), which generates components with varying amplitudes and frequencies. The EMD process includes an inner loop called sifting, which produces an Intrinsic Mode Function (IMF) until the signal reaches a mean value of zero or a maximum number of iterations. The obtained IMF is a characteristic function of a fundamental oscillation that is symmetrical around the abscissa. The dominant oscillatory mode's frequency can be determined by applying the Hilbert transformation to the first IMF, and the damping ratio and damping can be calculated by fitting a least square line to the logarithmic instantaneous amplitude of the first IMF. To demonstrate the efficacy of the methodology, three case studies are examined. The first case involves generating a synthetic signal to simulate a load angle change with a defined frequency and damping. In the second case, a small disturbance in mechanical power change in the Single Machine System is simulated. The third case simulates a three-phase short circuit on the transmission line using the IEEE 39 bus test system. The results are compared to modal analysis conducted in DigSilent PowerFactory software. The application of HHT yielded satisfactory and promising results in identifying the dominant mode's oscillation frequency and damping.

The paper presents an algorithm for determining the optimal connection location and power of a photovoltaic plant in a distribution network. The proposed algorithm is based on the use of the fuzzy logic and power flow calculation method. The fuzzy logic is used for the selection of candidate buses for the photovoltaic plant connection, while load flow analysis is used for the verification of voltage conditions and power losses in the distribution network. For each of the candidate buses photovoltaic plant of a certain power range was considered. The practical application of the considered algorithm was demonstrated on a part of Sarajevo's 10 kV distribution network.

Abstract Underfrequency load shedding is a common technique for maintaining the stability of the power system by removing the overload in a certain part of the system after a disturbance. The purpose of underfrequency load shedding is to balance output and load when a particular event causes a significant frequency drop in the power system. In conventional underfrequency load shedding schemes, the frequency thresholds of frequency relays are constant, this way it is difficult and sometimes impossible to control the frequency in various disturbances in the system. In this paper, an adaptive underfrequency load shedding (AUFLS) algorithm that is independent of communication between relays is presented. The relays are tuned to reduce loads taking into account local parameters such as voltage and frequency to prevent the occurrence of a cascade failure that can ultimately lead to the breakdown of the entire power system. In this paper, the rate of change of frequency (ROCOF) is obtained by applying the Hilbert-Huang transformation. Numerical simulations conducted on the New England 39 bus test system in the DIgSILENT PowerFactory and MATLAB software packages confirm the effectiveness of the proposed approach.

In this paper approach for the experimental determination of the grounding system impulse impedance under the presence of the high-frequency electromagnetic interference is presented. The considered approach is based on the application of the discrete wavelet transform on the measured signals. Validation of the considered approach has been conducted in several experiments using a vertical grounding electrode. The experimental investigation has been performed using different impulse current peak values and different front rise times. On all measured current and voltage waveforms, high-frequency interferences were registered.

This paper considers the method for the calculation of magnetic flux density in the vicinity of overhead distribution lines which takes into account the higher current harmonics. This method is based on the Biot–Savart law and the complex image method. The considered method calculates the values of the magnetic flux density for each harmonic component of the current separately at all points of interest (usually lateral profile). In this way, it is possible to determine the contributions of individual harmonic components of the current intensity to the total value of magnetic flux density. Based on the contributions of individual harmonic components, the total (resultant) value of the magnetic flux density at points of interest is determined. Validation of the computational method is carried out by comparison of the results obtained by the considered calculation method with measurement results. Furthermore, the application of the calculation method was demonstrated by calculating magnetic flux density harmonics in the vicinity of two overhead distribution lines of typical phase conductor arrangements.

In this paper, a novel method for the magnetic flux density estimation in the vicinity of multi-circuit overhead transmission lines is proposed. The proposed method is based on a fully connected feed-forward artificial neural network model that is trained to estimate the magnetic flux density vector components for a range of single-circuit overhead transmission lines. The proposed algorithm is able to simplify estimation process in instances when there are two or more geometrically identical circuits present in the multi-circuit overhead transmission line. In such instances, artificial neural network model is employed to estimate the magnetic flux density distribution over a considered lateral profile for only one of such circuits. The magnetic flux density estimates of the other geometrically identical circuits are derived from these results. The proposed methodology defines the resultant magnetic flux density for the multi-circuit overhead transmission line in terms of the contributions made by individual circuits. The application of the proposed magnetic flux density estimation method is demonstrated on several multi-circuit configurations of overhead transmission lines. The performance of the proposed method is compared with the Biot-Savart law based method calculation results as well as with field measurement results.

Background: Epilepsy is a brain disorder characterised by unpredictable and excessive nerve cell activity that causes epileptic seizures. Epileptic seizures are more common in children and adolescents than in elderly population. Electroencephalography (EEG) is a diagram of electrical activity of the brain and it is used as a method of choice for diagnosing epilepsy. Despite the accurate EEG tracing of electrical activity in the brain, the disadvantage of this type of analysing is the doctor’s skill to read the EEG correctly. Objective: The aim of this study was ro represents further research presented in our pevious works with wavelet based EEG analysis after masuring a multiresolution as relation between time and frequency resolution. Methods: Signal database set consist of 51 patients: a) healthy patient; b) 50 patients with a diagnosis of epilepsy. Additional characteristics of the analysed data: a) 19 signals-channels of EEG, b) Duration – 20 s or 2688 samples and. Nowadays, we can find dozens of EEG signal analysis papers using mathematical approach and with a focus on identification of epilepsy. Results: This paper represents some results relating to the analysis of EEG in children using Wavelet Transform (WT). The signals was collected and analysed at the Department of neuropediatrics, Pediatric Clinic at the University Clinical Center, University of Sarajevo. Conclusion: Using this approach it is possible to clearly differentiate patients with a diagnosis of epilepsy from healthy ones.

The use of renewable energy sources increases the energy self-sustainability of cities, enabling citizens to reduce energy costs, which results in an increase in their standard of living. However, solar energy penetration in Bosnia and Herzegovina, and its capital Sarajevo, is not in line with the possibilities. Furthermore, the Sarajevo Canton is extremely polluted during the winter months because of the use of unacceptable heating fuel. The aim of this paper is to introduce photovoltaic power systems use in heating electrification system. In this paper AQI is calculated based on historical data and the hybrid model EMD-SARIMA for air pollution and a solar production forecast is presented. The methodology was tested in the Sarajevo Canton, taking into account 35,000 households. In order to ensure clean air, renewable electric energy use for household heating should be implemented. The widespread use of inefficient individual heating systems characterized by inefficient and expensive use of firewood and the use of coal in individual furnaces in populated areas are the main problems of internal and urban air pollution in Sarajevo Canton. In order to reduce energy poverty in Sarajevo Canton, the use of a floating photovoltaic power plant located on Lake Jablanica with a capacity of 30 MW and the solar prosumers with capacity of 115 MW to provide the 196 GWh necessary for heating electrification of 35,000 households is implemented in this paper. Finally, based on correlation between AQI forecast and solar production it was calculated that the values of the AQI, considering the application of solar energy during 150 days (five months) in one heating season, have significantly decreased. Also renewable energy sources have a very important role in reducing carbon dioxide (CO2) emissions into the atmosphere and reducing urban pollution. With this approach, households would be heated by renewable electricity, which would make Sarajevo a cleaner, smarter city.

Abstract The paper consists of three parts. In the introduction and the first part of this paper are given basic theoretical considerations on possible ways for treatment of the neutral point in distribution grids with special reference to the method of neutral grounding of distribution transformers through a low ohmic resistor and a compensation coil. The second part gives the use analysis of a low ohmic resistor and a compensation coil as the future choice of neutral point grounding on the particular distribution grid powered by a substation TS 35/10 kV. In the third part of the paper, the results were obtained using an adequate dynamic distribution model, using the EMTP-ATP software package. Also, in this part, calculations are made for neutral grounding through a low ohmic resistor, a compensation coil, as well as in the case of isolated grids, and a comparison of the obtained values of the overvoltage coefficients.

Abstract This paper introduces and compares the various techniques for identification and analysis of low frequency oscillations in a power system. Inter-area electromechanical oscillations are the focus of this paper. After multiresolution decomposition of characteristic signals, physical characteristics of system oscillations in signal components are identified and presented using the Fourier transform, Prony’s method, Matrix Pencil Analysis Method, S-transform, Global Wavelet Spectrum and Hilbert Huang transform (Hilbert Marginal Spectrum) in time-frequency domain representation. The analyses were performed on real frequency signals obtained from FNET/GridEye system during the earthquake that triggered the shutdown of the North Anna Nuclear Generating Station in the east coast of the United States. In addition, according to the obtained results the proposed methods have proven to be reliable for identification of the model parameters of low-frequency oscillation in power systems. The relevant analyses are carried out in MATLAB coding environment.