Simulation of the Radial Sawing Technique for Pedunculata Oak (Quercus robur L.) Logs
Using the RadSawSim simulator for radial sawing, a simulation of the radial sawing technique was used to saw Pedunculata oak (Quercus robur L.) logs. Simulation was implemented with a view to producing as many radially sawn boards as possible and took into account the influences of increasing volume yield, lumber value yield, and log-value yield. The methods that were analyzed were live sawing and radial sawing of third sections, fourth sections, fifth sections, and sixth sections of the log. Live sawing achieved the best results of volume yield during simulation, which was followed by radial sawing into the third, fourth, fifth, and sixth sections. The difference in volume yield with live sawing compared to the radial-sawing method is very large for logs up to a diameter of 45 cm. It becomes smaller when the log diameter is greater than 45 cm. A comparison of the radial method shows that the share of radially sawn boards and lumber value yield increased when the number of log sections during sawing simulation increased. If log-value yield is assumed to be the main criterion, and given the conditions used in this simulation, there is no justified reason to saw logs using the radial technique when the diameter is less than 45 cm. The live sawing technique is more efficient for these diameters of logs, and, therefore, the radial sawing technique is more efficient for logs with a diameter greater than 45 cm.